Caro and Kingi stole Australian hearts from The Block in season 5. Today, they're ambassadors for Renovator Store, and Caro's dropped by our blog to give our readers tips for painting like a pro!
Prep Work for Painting
Prep Work for Painting
- Fill any holes or imperfections with spackle, wait for it to dry, and then lightly sand the patches. If you have a crack, you must first widen it slightly before spackling or the spackle will just sit on top.
- Scrape away any peeling, cracked paint, and then sand the area smooth.
- Clean the walls if they may be dirty (especially in a kitchen or bathroom), and always take a damp cloth to clean the dust off of trim and the tops of doorways.
- Use paintable caulk to fill any gaps between the walls and trim before painting the trim. Fill any dings and divots in the wood with wood putty, wait for it to dry, then sand smooth.
- When in doubt, prime. Using a primer can hide dark colors, block stains, and help your new paint job last longer. It’s also a must when painting exposed woodwork, and there are many primers that adhere to glossy surfaces (allowing you to skip sanding first).
- Stir your paint before you begin, and don’t paint straight from the can. Obviously you would pour the paint into a roller tray if you were about to use a roller, but consider using a small bowl when painting with a brush. It’s easier to hold, and decanting paint will keep the can free of the impurities (dust, wood particles, etc.) that your brush may pick up as you work.
- If you want to use tape, buy painter’s tape (it’s usually blue or green, and marked as such). Apply it in short, overlapping strips, and press down firmly along the edge to ensure a crisp line.
- Keep a wet edge, and always paint from dry to wet. This will minimize brush strokes and roller marks.
- Taping is optional, especially if you have a reasonably steady hand. Using an angle brush, start slightly away from the edge and then curve in to meet it. This will help you avoid leaving a big blob of paint where you begin.
- Holding the brush the narrow way (not the way you would naturally hold it) makes it easier to get a crisp line when painting trim.
- Painting a room is best accomplished by first cutting in (painting along the trim, ceiling, and corners) with a brush. After that has dried, you can go in with a roller for the walls.
- Wet your brush and then blot out most of the water before you begin. This will help to keep paint from creeping up into the ferrule (the metal part where the bristles are attached) and save your brush.
- Only dip your brush about a half or quarter of an inch into the paint, then wipe off one side on the edge of the paint container. This will help you avoid paint runs (from using too much) and keep your brush in good condition.
- Paint in long, continuous strokes. Not doing so is one of the most common mistakes.
- When painting with a roller, aim for covering a three foot wide section at a time. I typically go from the ceiling to a midway point, load more paint, and then go from the midway point down to the floor. Then I move left or right to the next section, always remembering to keep a wet edge and working from dry to wet.
- When painting with a brush, don’t dab the paint on or move in a short back and forth motion. You can paint with the brush left and right (or up and down) to get the paint on, but then take one long finishing stroke from the dry side and tapering off into the wet edge.
- Put on a second coat. Your paint job may look OK after just one, but it will look better after two. If you’re using a dark or vivid color, you may even need three (or more) coats.
- Let your paint fully dry between coats. The paint can should tell you how long to wait.Want more Caro & Kingi wisdom? Check them out here: http://www.caroandkingi.com/